Checkline TT-QCM Manual do Utilizador descarregar pdf (Página 14)

Descri

tion of Functions

DESCRIPTION OF FUNCTIONS

The following is a description of the standard features of the AWS

product line.

OPERATING MODE

Current operating mode (Peak, 1st Peak or Track) will show on the

display. Press the Œ key to toggles between them.

Peak

Displays and retains the maximum torque experienced by the wrench, as

occurs when operating the wrench in the tightening direction. The Peak

Mode is used for all power tools and some dial wrenches.

1st Peak

Detects the “first peak” of torque experienced by the wrench, capturing

the initial torque as occurs when the torque wrench cams over. First

Peak is used primarily for Click torque wrenches and cam over

screwdrivers.

Track

Displays torque as it is being applied to the transducer. Track mode is

used primarily for verifying calibration of the unit.

ENGINEERING UNITS

Shows the current engineering units. Press the key to cycle

through the eight possible choices: Kgf m, KgfCm, gfCm, cNm, Nm, FT LB,

IN LB, IN OZ.

FULL SCALE

This screen shows the Full-Scale value of the Torque Shaft. This is not a

field adjustable value.

LOW LIMIT

Use the low limit setting as a means of visually flagging the operator

when a reading fails to reach a desired minimum value. A small down

arrow will appear on the screen if a peak is captured below the limit

setting.

AWS-

Guide

1 2 ... 9 10 11 12 13 14 15 16

Sem comentários

Checkline TT-QCM Manual do Utilizador Página 14